← Explore the instruments, effects & screen previews
New code.
New instrument.
Try the sounds behind our upcoming Amen instrument.
Install an early release on your compatible Daisy Pod.
First, the bootloader.
Most releases need Amen Bootloader first—the small starter program that lets your Seed load them. Set it up once, then switch between QSPI instruments without reinstalling it.
Granular Timestretch is the exception: its internal-flash build skips this step and replaces any installed bootloader.
Prepare once.
Play many instruments.
The bootloader is the small program that installs and starts your instruments. It is not an instrument itself. Amen Bootloader includes the corrected read-back verification and appears by that name over USB.
- Enter STM32 recovery modeHold BOOT, press and release RESET, then release BOOT. Use a USB data cable connected to the Seed.
- Connect and installSelect the STM32 DFU device, often “DFU in FS Mode”. Confirm your hardware and install Amen Bootloader. Wait for verification.
- Return for your instrumentPress RESET, then press BOOT while the LED pulses. Choose a QSPI instrument and reconnect to “Amen Bootloader”.
Replaces internal firmware; preserves the QSPI instrument. STM32 recovery mode keeps its factory USB name. An internal-flash instrument will replace this bootloader.
Bootloader guide & recovery ↗Loading firmware library…
Made for the Daisy Seed on a Pod.
Choose the build that matches
your hardware.
Granular
Timestretch
Capture a moment. Stretch it into something else. Dual-grain looping, reverse playback and stereo spray.
Meet your
next sound.
Connect your Pod with a USB data cable. Hold BOOT, press and release RESET, then release BOOT.
Chrome or Edge on desktop · USB stays local
Full controls & manualsControls, installation & recovery ＋
If installation fails, reconnect in the correct bootloader mode and retry. Don’t unplug during a transfer. A completed transfer does not verify audio operation. Official Daisy programmer ↗